INSTALLATION


Everything is simple with Heatplus! To install the systems we provide you must follow a few simple steps.

Warning! For electrical connections, please contact a licensed electrician.


Installing heating mats:


a) Roll the heating mat on the floor

b) Cut off the heating mat when you reach the wall or an obstruction but dont cut the heating cable

c) Rotate the heating mat and continue installing until entire surface is covered

d) Place the sensor under the floor mat in one of the cable loops

e) Remove the backing of the adhesive tape

f) Make sure that both sections of each mat (orange warnings) are laid on the floor surface

g) After testing each heating mat with a measuring device, cover with flexible tile adhesive or floor leveling compound and then install the final flooring 


instalare 1    insalare 2



instalare 3    instalare 4



instalare 5    instalare 6



Installing Under Laminate mat:


a) Place the sheets of thermal insulation (polystyrene) on the floor surface and secure them with strips of aluminum tape

b) Roll out the heating mat

c) Cut off the heating mat when you reach the wall or an obstruction but dont cut the heating cable

d) Rotate the heating mat and continue installing until entire surface is covered

e) Create several slits in the insulation board to properly position the power cable (black) and temperature sensor

f) Tape the edge of the heating mats and exposedcables with aluminium tape

g) Install the laminate flooring directly on the surface the heating mat


instalare alumat 1    instalare alumat 2



instalare alumat 3    instalare alumat 4



instalare alumat 5    instalare alumat 6


Install 3mm heating cables:



Usually when installing the heating cables you should calculate the distance between the heating cable loops arising from power requirement per m2. Based on this value you can move on to installing the heating cable.


a) Lay the strips of self adhesive tape on the floor surface

b) Remove the backing from the adhesive tape

c) Mark the distance according to your calculations

d) Lay the cable to the distances chosen and used tape to secure the cable loops

e) After covering the entire floor using self-adhesive tape for attaching heating cable

f) Place a temperature sensor in the cable loop and fix the warning label.

g) Test the heating cable with a multimeter and cover with flexible tile adhesive and then install the final floor.


instalare 7    instalare 8



instalare 9    instalare 10



instalare 11    instalare cablul 3mm



For additional information about Heatplus products and installation details please contact us or our partners.